Machine Design

121. The ultimate strength of steel in tension in comparison to shear is in the ratio of

1. 1 : l
2. 02:01
3. 03:02
4. 02:03
5. 01:02

View answer

122. The usual clearance provided in hydrodynamic bearing per mm of diameter of shaft is

1. 0.01 micron
2. 0.1 micron
3. 1 micron
4. 10 microns
5. 25 microns.

View answer

123. The valve rod in a steam engine is connected to an eccentric rod by

1. cotter joint
2. bolted joint
3. kunckle joint
4. universal coupling
5. gib and cotter joint.

View answer

124. Three different weights fall from a certain height under vacuum. They will take

1. same time to reach earth
2. times proportional to weight to reach earth
3. times inversely proportional to weight to reach earth
4. unpredictable
5. none of the above.

View answer

125. Transverse fillet welded joints are designed for

1. tensile strength
2. compressive strength
3. shear strength
4. bending strength
5. torsional strength.

View answer

126. Turn buckle has

1. right hand threads on bout ends
2. left hand threads on both ends
3. left hand threads on one end and right hand threads on other end
4. no threads
5. threads in middle portion.

View answer

127. When a bolt is subjected to shock loading, the resilience of the bolt should be considered in order to prevent breakage at

1. shank
2. head
3. in the middle
4. at the thread
5. anywhere in the bolt.

View answer

128. When a close coiled helical spring is compressed, its wire is subjected to

1. tension
2. shear
3. compression
4. all of the above
5. none of the above.

View answer

129. When a nut is tightened by plaping a washer below it, the bolt will be subjected to following type of loads

1. compression
2. tension
3. shear
4. combined loads
5. all of the above.

View answer

130. When two springs are in series (having stiffness K), the equivalent stiffness will be

1. K
2. K/2
3. 2K
4. KIA
5. UK.

View answer