Transistor Tuned Amplifiers

21. Frequencies above __________ kHz are called radio frequencies

  1. 21
  2. 0
  3. 50
  4. 200

Correct answer: (D)
200

22. If a high degree of selectivity is desired, then double-tuned circuit should have __________ coupling

  1. Loose
  2. Tight
  3. Critical
  4. None of the above

Correct answer: (A)
Loose

23. If L/C ratio of a parallel LC circuit is increased, the Q of the circuit __________

  1. Is decreased
  2. Is increased
  3. Remains the same
  4. None of the above

Correct answer: (B)
Is increased

24. If Q of an LC circuit increases, then bandwidth __________

  1. Increases
  2. Decreases
  3. Remains the same
  4. Insufficient data

Correct answer: (B)
Decreases

25. If the resistance of a tuned circuit is increased, the Q of the circuit __________

  1. Is increased
  2. Is decreased
  3. Remains the same
  4. None of the above

Correct answer: (B)
Is decreased

26. In a parallel LC circuit, if the input signal frequency is increased above resonant frequency then __________

  1. XL increases and XC decreases
  2. XL decreases and XC increases
  3. Both XL and XC increase
  4. Both XL and XC decrease

Correct answer: (A)
XL increases and XC decreases

27. In a parallel LC circuit, if the signal frequency is decreased below the resonant frequency, then __________

  1. XL decreases and XC increases
  2. XL increases and XC decreases
  3. Line current becomes minimum
  4. None of the above

Correct answer: (A)
XL decreases and XC increases

28. In parallel resonance, the circuit impedance is __________

  1. C/LR
  2. R/LC
  3. CR/L
  4. L/CR

Correct answer: (D)
L/CR

29. In parallel resonance, there is __________

  1. Both voltage and current amplification
  2. Voltage amplifications
  3. Current amplification
  4. None of the above

Correct answer: (C)
Current amplification

30. In series resonance, there is __________

  1. Voltage amplification
  2. Current amplification
  3. Both voltage and current amplification
  4. None of the above

Correct answer: (A)
Voltage amplification

Page 3 of 4