Electronic Circuits

101. The capacitors are considered _________ in the ac equivalent circuit of a transistor amplifier.

  1. Open
  2. Partially open
  3. Short
  4. Partially short

Correct answer: (C)
Short

102. The capacitors are considered _________ in the dc equivalent circuit of a transistor amplifier.

  1. Short
  2. Partially short
  3. Open
  4. Partially open

Correct answer: (C)
Open

103. The collector current in an common base configuration is equal to

  1. Alpha times emitter current plus leakage current
  2. Alpha times base current plus leakage current
  3. Beta times emitter current plus leakage current
  4. Beta times collector current plus leakage current

Correct answer: (A)
Alpha times emitter current plus leakage current

104. The common base (CB) amplifier has a _________ compared to CE and CC amplifier.

  1. Lower input resistance
  2. Larger current gain
  3. Larger voltage gain
  4. Higher input resistance

Correct answer: (A)
Lower input resistance

105. The coupling capacitor Cc must be large enough to _________ in an RC coupling scheme.

  1. Pass dc between the stages
  2. Dissipate high power
  3. Prevent attenuation of low frequency
  4. Prevent attenuation of high frequency

Correct answer: (C)
Prevent attenuation of low frequency

106. The crystal oscillator frequency is very stable due to _________ of the crystal.

  1. Rigidity
  2. Ductility
  3. High Q
  4. Low Q

Correct answer: (C)
High Q

107. The current gain of an emitter follower is

  1. Equal to 1
  2. Greater than 1
  3. Less than 1
  4. Zero

Correct answer: (C)
Less than 1

108. The current in any branch of a transistor amplifier that is operating is

  1. ac only
  2. the sum of ac and dc
  3. the difference of ac and dc
  4. dc only

Correct answer: (B)
the sum of ac and dc

109. The driver stage usually employs _________ amplifier.

  1. Class A power
  2. Class C
  3. Push-pull
  4. Class AB

Correct answer: (A)
Class A power

110. The driver transformer has center- tapped secondary to provide

  1. Forward bias to transistors of push-pull circuit
  2. Two signals 180 degrees out of phase to transistors of push-pull circuit
  3. Impedance matching
  4. Two signals in phase with each other

Correct answer: (B)
Two signals 180 degrees out of phase to transistors of push-pull circuit

Page 11 of 25