Economics of Power Generation

91. Which of the following is not a source of power?

  1. Thermocouple
  2. Photovoltaic cell
  3. Solar cell
  4. Photoelectric cell

Correct answer: (A)
Thermocouple

92. Which of the following is not necessarily an advantage of interconnecting various power stations?

  1. Improved frequency of power supplied
  2. Reduction in total installed capacity
  3. Increased reliability
  4. Economy in operation of plants

Correct answer: (A)
Improved frequency of power supplied

93. Which of the following is the disadvantage due to low power factor?

  1. Poor voltage regulation
  2. Increased transmission losses
  3. High cost of equipment for a given load
  4. All of the above

Correct answer: (D)
All of the above

94. Which of the following is the disadvantage of a synchronous condenser?

  1. High maintenance cost
  2. Continuous losses in motor
  3. Noise
  4. All of the above

Correct answer: (D)
All of the above

95. Which of the following is the disadvantage of static capacitor for power factor improvement?

  1. Easily damaged by high voltage
  2. Cannot be repaired
  3. Short service life
  4. All of the above

Correct answer: (D)
All of the above

96. Which of the following is the essential requirement of peak load plant?

  1. It should run at high speed
  2. It should produce high voltage
  3. It should be small in size
  4. It should be capable of starting quickly

Correct answer: (D)
It should be capable of starting quickly

97. Which of the following place is not associated with nuclear power plants in India?

  1. Narora
  2. Tarapur
  3. Kota
  4. Benglore

Correct answer: (D)
Benglore

98. Which of the following plants is almost inevitably used as base load plant?

  1. Diesel engine plant
  2. Gas turbine plant
  3. Nuclear power plant
  4. Pumped storage plant

Correct answer: (C)
Nuclear power plant

99. which of the following plants?

  1. Base load plants
  2. Peak load plants
  3. Both (a) and (b)
  4. none of the above

Correct answer: (B)
Peak load plants

100. Which of the following power plants need the least period for installation?

  1. Thermal power plant
  2. Diesel power plant
  3. Nuclear power plant
  4. Hydro-electric power plant

Correct answer: (B)
Diesel power plant

Page 10 of 11